1
PART NAMES
This chapter describes the part names of the Simple Motion module.
2-4.5 Mounting hole
[3]
[2]
[1]
[12]
[13]
No.
Name
[1]
External input connection connector
[2]
Extension cable
Direct mounting hole: 2 holes of 4.5 (0.18") (mounting screw:
[3]
M4 screw)
[4]
Axis display LED (AX1, AX2, AX3, AX4)
[5]
POWER LED
[6]
RUN LED
[7]
ERROR LED
[8]
Extension connector
[9]
DIN rail mounting groove
[10]
Name plate
[11]
DIN rail mounting hook
[12]
Pullout tab
[13]
Power supply connector
[14]
SSCNET cable connector
[4]
[5]
[6]
[7]
[8]
[14]
Description
Connects to a mechanical system input, manual pulse generator/incremental
synchronous encoder, or forced stop input. (26-pin connector)
For the signal layout, refer to the following.
Page 19 Specifications of Interfaces with External Devices
Connects to a CPU module, etc.
Holes which are used when installed directly.
For details, refer to the following.
Page 16 LED Display Specifications
Connects to an expansion module on the next tier.
Using this slot, the module can be mounted to DIN rail "DIN46277" (width: 35 mm).
Serial No. etc., are printed.
Hook which is used for mounting the module onto the DIN rail.
Tab for removing from a CPU module, etc.
Connects to a module to the power.
Connects to a servo amplifier.
[9]
[10]
[11]
1 PART NAMES
1
15