Table of Contents
Advertisement
Figure 15. Installing the storage drive bracket
6. Connect the signal cable and the power cable to the new storage drive.
7. Reinstall the removed parts. To complete the replacement, see "Complete the parts replacement" on
page 58.
M.2 solid-state drive
Prerequisite
Before you start, read Appendix A "Important safety information" on page 65 and print the following
instructions.
Replacement procedure
1. Remove the computer cover. See "Computer cover" on page 42.
2. Remove the front bezel. See "Front bezel" on page 42.
3. Remove the optical drive. See "Optical drive" on page 43.
4. Remove the storage drive bracket. See "Storage drive" on page 45.
5. Depending on your computer model, refer to one of the following to replace the M.2 solid-state drive.
• Type 1
Figure 16. Removing the screw
.
Chapter 7
CRU replacement
49
Advertisement
Table of Contents
