Emerson Rosemount 3051S Manual Supplement page 19

Manual Supplement
00809-0100-4851, Rev AA
1. Remove the housing cover on the field terminal side.
2. Connect the black power module.
2.6 Verify configuration
Use any compliant master to communicate with and verify configuration of the transmitter. Make sure to
download the latest device driver from the
device revision for each potential configuration.
Configuration can be verified using two methods:
1. By using the Field Communicator
2. Via AMS
Fast Keys for using a Field Communicator are provided below in
To verify WirelessHART operation with an local display (LCD), refer to
done at the device via the LCD display.
Table 1-2. Device Revisions
Device configuration
Rosemount 3051SHP HART (wired)
Rosemount 3051SHP F
Rosemount 3051SHP WirelessHART
Rosemount 3051SHP MultiVariable
Rosemount 3051SHP HART Diagnostics (DA2)
2.6.1 Verify with Field Communicator
Connecting to a Field Communicator
For the Field Communicator to interface with the transmitter, power must be supplied to the transmitter.
For wireless configuration, the communicator connections are located behind the power module on the
terminal block (see
block (see
Rosemount 3051S High Pressure
™
Device Manager
Fieldbus
OUNDATION
™
Figure 1-14, image A). For wired configurations, the connections are on the terminal
Figure 1-14, image B, C, or D).
Device Install Kit site. Refer to
Table
Device revision
Rev. 7
Rev. 23
Rev. 3
Rev. 1
Rev. 3
Rosemount 3051S High Pressure
Table 1-2 below for the latest
1-3.
page 21; verification can also be
2017
19