Table of Contents
Advertisement
Additional Tools Needed for Assembly
- #2 Phillips Screwdriver
- 18mm (11/16") or Adjustable Wrench
- Mallet or Hammer with Piece of Wood
THE MACHINE MUST NOT BE
PLUGGED IN AND THE POWER SWITCH MUST BE IN
THE OFF POSITION UNTIL ASSEMBLY IS COMPLETE.
BASE AND COLUMN ASSEMBLY
1. Place the base (A-Fig. 1) on a level floor where
the machine will be used.
2. Attach the column (B-Fig.1) to the base
(A-Fig. 1) using four M12x40 hex bolts. Tighten all
four bolts with a 18mm, 11/16" or adjustable wrench.
Assistance is needed for this next
NOTE:
step. The Table Assembly is very
large and heavy to lift.
3. Using a hex wrench, remove the assembled
Collar and Rack from the column.
4. Place rack (C-Fig. 2) inside the table support
bracket (D-Fig. 2), lining up the rack's teeth with
the worm gear that is inside of the table bracket.
5. Lift up and slide the table assembly with the
rack together onto the column, and slide them
down the column until the rack fits back into the
column support base.
6. Replace the column collar on top of the rack,
and secure it in place with a hex wrench. Fig. 3.
7. Install the raising/lowering crank handle onto
the table bracket's worm gear shaft with a hex
wrench (Figure 4). The handle's set screw must
line up and be secured on the flat section of the
table support's worm gear shaft.
Continued on page 10
ASSEMBLY
B
A
9
Figure 1
Figure 2
Collar
Collar
Rack
Hex
Wrench
Table
Bracket
Figure 3
Figure 4
C
D
Advertisement
Table of Contents
