Table of Contents
Advertisement
Continued from page 13
6. Swing back the tension lever until there is ap-
proximately 1/2" deflection in the belt (Fig. 21).
7. Tighten the locking knob on the both sides of
drill press head.
8. Close the belt guard and reconnect the drill
press to the power.
CHANGING THE BELTS
To change a worn belt, follow the same basic
steps for Changing Spindle Speeds, pgs 13 & 14:
- Release the belt tension (steps 1-3)
- Remove the old belt from the pulleys
- Install the new belt onto the pulleys
- Reset the belt tension (steps 4-8)
SETTING THE SPINDLE LOCK
1. Loosen the depth stop collar lock (A-Figure 22).
2. Lower the spindle to the desired depth.
(Figure 23).
3. Turn the depth stop collar clockwise until the
collar stops (B-Figure 22).
4. Tighten the depth stop collar lock.
SETTING THE DRILL DEPTH
1. With the spindle in the up position, loosen the
depth stop collar lock (A-Figure 22) as shown.
2. Turn the depth stop collar clockwise until the
pointer reads the desired drill depth on the scale
(B-Figure 22).
3. Tighten the depth stop collar lock.
ADJUSTMENTS
FIGURE 21
PLUGGED IN AND THE POWER SWITCH MUST BE IN THE
OFF POSITION UNTIL ALL ADJUSTMENTS ARE COMPLETE.
14
BELT DEFLECTION
THE MACHINE MUST NOT BE
A
B
Figure 22
Figure 23
Advertisement
Table of Contents
