Table of Contents
Advertisement
Turn the power switch "OFF" and disconnect the plug from the outlet prior to adjusting
or maintaining the machine. DO NOT attempt to repair or maintain the electrical components of the motor.
Contact a qualified service technician for this type of maintenance.
1. Before each use:
- Check the power cord and plug for any wear or
damage.
- Check for any loose screws, hardware or parts.
- Check the area to make sure it is clear of any
misplaced tools, lumber, cleaning supplies, etc. that
could hamper the safe operation of the machine.
2. To avoid a build-up of wood dust, regularly clean
all parts of the machine using a soft cloth, brush or
compressed air. A general cleaning should be done
after every use to avoid future problems and ensure
the machine is in ready condition for its next use.
WARNING: If blowing sawdust, wear proper eye pro-
tection to prevent debris from blowing into eyes.
3. Keep the machined surfaces of the drill press table
and base free of resin and rust. Clean them regularly
with a non-flammable solvent, then coat with a light
film of dry lubricant spray or wax.
4. Lubricate the table bracket and locking lever bolts
to keep them operating smoothly.
DO NOT attempt to repair or maintain the electrical components of the motor.
MAINTENANCE
WIRING DIAGRAM
This machine must be grounded. Replacement of the power supply cable should only
be done by a qualified electrician. See page 5 for additional electrical information.
Contact a qualified service technician for this type of maintenance.
5. Clean the column on a regular basis to prevent
the build-up of dust, drilling residue and rust. Treat
the posts with a dry lubricant spray or a light coating
of wax. Do not use ordinary oil which will collect dust
and hamper the movement of parts along the column.
6. Periodically, lower the quill assembly and apply
a light coating of machine oil to the quill and spindle
surfaces. Raise and lower the quill a few times to
distribute the oil on all of the internal surfaces.
7. Apply #2 tube grease to the worm gears in the
table elevation mechanism and rack to keep them
operating smoothly.
8. The ball bearings in the spindle and pulley assem-
blies are lifetime lubricated, sealed, and do not need
any further care.
9. Keep the drive belt and pulley surfaces free of oil
and grease. Periodically, check the drive belt for wear
and replace if necessary.
16
Advertisement
Table of Contents
