Table of Contents
Advertisement
THE MACHINE MUST NOT BE
PLUGGED IN AND THE POWER SWITCH MUST BE IN
THE OFF POSITION UNTIL ASSEMBLY IS COMPLETE.
BASE AND COLUMN ASSEMBLY
1. Place the base (A-Fig. 1) on a level floor where
the machine will be used.
2. Attach the column (B-Fig.1) to the base (A-Fig.
1) using four M8x20 hex bolts. Tighten all four
bolts.
3. Using a hex wrench (C-Fig. 2) remove the
column collar (D-Fig. 2) as shown.
4. Insert the worm elevation gear (E-Fig. 3) into
the table support bracket (F-Fig. 3) as shown.
5. Place rack (G-Fig. 4) inside the table support
bracket (F-Fig. 4) lining up the teeth as shown.
6. Slide the table support and rack assembly over
the column and replace the column collar.
HEAD ASSEMBLY
1. Place the locking shoe (part# 15B) in the
recessed pocket of the head. Fig. 5.
CONTINUED ON PAGE 10
E
F
Figure 3
ASSEMBLY
A
9
B
Figure 1
Figure 2
Figure 4
Figure 5
D
C
G
F
Advertisement
Table of Contents
