Table of Contents
Advertisement
Continued from page 9
8. Install the locking lever handle onto the table
support bracket. Tightening the locking lever
handle secures the table support to the column
so that it does not move during the remaining
assembly steps, and in normal drill press
operation (Figure 5).
Assistance is needed for this next
NOTE:
step.
HEAD ASSEMBLY
1. Place the drill press head onto the column as
far as it will go (Figure 6).
2. Align the drill press head with the base of the
drill press.
3. Tighten the drill press head to the column by
tightening the two set screws on the right side of
the head as shown (A-Figure 7).
4. Install the 3 feed handles into the threaded
holes in the handle hub (Figure 8).
5. Install the belt cover handle knob. Open the
belt cover and insert the Phillips head screw
through the hole in the lid from the inside. Thread
the knob on the outside of the belt cover and
tighten it in place on the screw with a screwdriver
(Figure 9).
NOTE: Setting the Spindle Speed and Tension of
the drive belts is covered on pages 13 and 14.
ASSEMBLY
Figure 9
PLUGGED IN AND THE POWER SWITCH MUST BE IN
THE OFF POSITION UNTIL ASSEMBLY IS COMPLETE.
10
Figure 5
THE MACHINE MUST NOT BE
Figure 6
A
Figure 7
Figure 8
Advertisement
Table of Contents
