Touchscreen Consoles Only - Precor Experience Series 700 Line Assembly Manual

Touchscreen consoles only

To attach the filter to the drive power cable:
1. Disconnect the existing power cable from the drive unit, power filter, and ground
terminal. Then completely remove it from the treadmill.
2. Connect the new power cable according to Figure 13 and Table 1.
Figure 12
Figure 13
Table 1
Position Connector
Drive input connectors
Brown lead with quick-connect terminal
Blue lead with quick-connect terminal
Green and yellow lead with quick-connect terminal
AC input cable to the power cable
3. Use the Velcro fasteners to attach the power supply to the right side of the front
cross member on the treadmill base. Plug the AC input cable into the socket on
the power supply.
4. Route the DC output cable through the cable ties behind the power supply,
toward the upright support on your right. Bend the cable ties over the DC output
cable to hold it in place.
Note Bundle the excess cable and secure it under the cable clips.
5. Connect the black, AC power cable on the AC wiring harness to the socket on
the power supply.
Important The touchscreen console includes an accessory jack panel that you must
install on the treadmill. The panel connects the TV and Ethernet cables to the facility's
network.
8