Safety Code - Precor Experience Series 700 Line Assembly Manual

Hide thumbs Also See for Experience Series 700 Line:

Table of Contents

Enlarged version

Safety code

Activate a safety code to prevent unauthorized use of the treadmill. This setting

requires the exerciser to enter a code (1 2 3 4) on the keypad before the treadmill

will operate.

To activate a safety code for your setting:

Enter code 5651565 to go to Club Settings.

Press OK for Safety Code setting.

Use the up/down arrows to enable the setting.

4. Press OK to save the setting.

Test the Safety Code.

Note If the safety code is properly enabled, you will be prompted to enter a

safety code (1 2 3 4) on the key pad before you can begin a workout.

Treadmill Auto Stop

Important The default setting for this feature is ON. An administrator can turn off this

feature in the System Settings; however, Precor recommends it remain ON.

Auto Stop™ (Automatic Stop) is a feature designed to bring the treadmill to a gradual

stop when it is not in use (after two minutes). This might occur if an exerciser steps

off the treadmill before the end of a workout and leaves the treadmill running.

To test Auto Stop



Start any workout on the treadmill, but DO NOT step onto the running belt.

Wait two minutes without stepping onto the running belt. At this point or shortly

beforehand, the treadmill should slow to a stop and the console should ask the

previous user to confirm that he or she is still present. If there is no confirmation,

the console returns to the Welcome screen or banner and it is safe to step onto

the running belt.

Table of Contents