Precor Experience Series 700 Line Assembly Manual page 7

To attach the heart rate bar:
1. Position the heart rate bar assembly against the dash frame and attach it using
two screws and two washers
2. Route the heart rate cable up through the back frame and out through the top
hole.
3. Remove the screw from the bottom of the tread arm.
. Partially tighten the fasteners.
Figure 8
Figure 9
4. Fit the tread arm into the heart rate bar and against the dash assembly.
Attach it using two screws
partially tighten the screws.
5. Attach the underside of each heart rate arm using one screw
Fully tighten.
6. Repeat Steps 3 through 5 to attach the other arm and then fully
tighten screws to 25 ft-lb.
and two washers . Use a hex key to
Figure 10
.
Figure 11
7