How To Reassemble The Feed Eccentric Rod No. D 85506 And The Connecting Rods Of The Stitch Length Regulating Mechanism - Necchi Supernova Instructions Manual

HOW TO REASSEMBLE THE FEED ECCENTRIC
ROD NO. D 85506 AND THE CONNECTING RODS
OF THE STITCH LENGTH REGULATING MECHANISM
(FIGS. 74 AND 75)
1) Insert the reverse stitch plate "5 " (which is connected
with the
reverse stitch control button) on the bushing " 6 " which is fixed
inside the casting of the arm and, at the same time, insert the
reverse stitch control button into its proper hole in the arm, from
the inside outwards. Proceed as follows: first insert the reverse
stitch control button into its hole in the arm, and then place the
plate " 5 " on bushing " 6 ".
Note: The reverse stitch plate must be so positioned that its pin
" 10 " is located between the two thread portions of the regulating
shaft, as shown in Fig. 76.
Assemble the stitch length lever " 4 " (see Fig. 75) by inserting its
pivot " C " into the bushing " 6 " which is fixed to the inside of
the arm casting.
Note: The stitch length lever " 4 " must be positioned in relation
to the reverse stitch lever " 5 " as shown in Fig. 36.
Slip the retaining ring " 2 " in the groove of pivot " C " of the
stitch length lever " 4 " (Fig. 75).
Assemble the feed eccentric connecting rod No. D 85506 with the
stitch regulator connecting rod " 1 " (see Fig. 76) in the following
manner:
Place connecting rod " 1 " (No. D 85512) on the pivot stud
" D " of the feed eccentric connecting rod No. D 85506.
Slip the forked portion of connecting rod No. D 85506 (with
connecting rod " 1 " hanging down on it) over the feed eccen
tric No. 20026.
Move the feed eccentric No. 20026, together with the connect-
87
Copyright -2004