required direction until the false needle lies between the two lines
"A". Tighten screw No. 048050 GEB firmly and remove the gauge.
Carry out the adjustments I, II, III, IV of the instruction: " Tim
ing of shuttle and needle bar " (page 13).
Now, sew with the machine.
a) If the machine sews correctly:
Place a sharply pointed pin into the tapered pin hole of the oscillating
crank shaft and mark on the carrier shaft the position of the hole to be
drilled and reamed in the carrier shaft. Remove the carrier shaft
assembly, then drill and ream the tapered pin hole in the carrier shaft.
Next, assemble with machine, using the ta-
t
Point of
Center of needle
shuttle or
Point of
hook -
Movement
Moveme
\ J /
nt
position of
Needle
Fig. 30
Needle
eye
shuttle or hook
Lowest
the needle
33
Copyright -2004