Changing From Automatic Sewing To Straight Sewing; Swing The Cam Disengaging Lever; Cleaning Of Shuttle Race And Feed Dog - Necchi Supernova Instructions Manual

Changing from automatic sewing to straight sewing.

Disconnect the "Automatic" as already explained on page 4.
Remove the cams from the machine by proceeding as follows:
Swing the Cam Disengaging Lever (at the rear of the arm)
entirely to the left as far as it will go.
Open the small cover on top of the arm and take out the cams.
Close small cover again.
Swing back the Cam Disengaging Lever entirely to the right as
far as it will go.
The machine is now ready for straight sewing.
Fig. 5

Cleaning of shuttle race and feed dog.

Bring the needle up to its highest position by turning the balance
Wheel toward you. Move slide plate to extreme left. h) Tilt the
machine back on its hinges, so that the underside is in
Full view. c) Rotate the needle plate release lever (Fig. 6) in the
direction of
Arrow "C "until the center stud in the needle plate becomes free,
Then remove the needle plate.
13
Copyright -2004
Fig. 6