Necchi Supernova Instructions Manual page 73

Fig. 64
Fig. 63
Fig. 65
The presser bar lever is partially raised (see Fig. 64). This is the
intermediate (or embroidery) position. In this position, a white
triangle in the presser bar lever lines up with a horizontal timing
mark on the arm. With the lever in this position, the presser foot
is kept raised just sufficiently high to permit the passage of the
embroidery hoop below it, while the tension of the upper thread
remains unchanged.
The presser bar lever is raised completely (Fig. 65).
In this instance, the presser foot does not rest upon the needle
plate (or the feed dog) and both tension discs are separated from
each other (the upper thread is under no tension). In this position
of the presser bar lever, the bottom face of the presser foot
should be about 9/32" above the needle plate (Fig. 65).
73
Copyright -2004