Table of Contents
Advertisement
After either dryer has operated for approximately five
minutes, observe burner flame through lower front
panel. Adjust the air shutter to obtain a soft, uniform
blue flame. (A lazy, yellow-tipped flame indicates lack
of air. A harsh, roaring, very blue flame indicates too
much air.) Adjust the air shutter as follows:
1. Loosen the air shutter lockscrew.
2. Turn the air shutter to the left to get a luminous
yellow-tipped flame, then turn it back slowly to
the right to obtain a steady, soft blue flame.
3. After the air shutter is adjusted for proper flame,
tighten the air shutter lockscrew securely.
4. Reinstall the lower front panel.
1
Closed Position
2
Shut-Off Valve Handle
3
Air Shutter Lockscrew
4
Air Shutter
512691R4
1
6
5
© Copyright, Alliance Laundry Systems LLC – DO NOT COPY or TRANSMIT
To reduce the risk of serious injury or death,
the lower front panel must be in place
during normal operation.
After either dryer has operated for approximately three
minutes, exhaust air or exhaust pipe should be warm.
2
5
1/8 in. (3.1 mm) Pipe Plug
(For checking manifold pressure)
6
Open Position
Figure 21
WARNING
3
4
DRY212N
Installation
W158
DRY212N
21
Advertisement
Table of Contents
