Table of Contents
Advertisement
Gas Dryers
NOTE: The wiring diagram is located inside the
control hood.
WARNING
To reduce the risk of fire, electric shock or
personal injury, all wiring and earthing to
each dryer MUST conform with the latest
edition of the Australian Electrical
Standards, AS3000, SAA wiring rules, and
such local regulations that might apply.
Each dryer is designed to be operated on a two wire,
plus earth wire, 240 Volt, 50 Hertz, single phase
circuit, fused at 10 Amperes.
Insert each dryer's lead-in cord plug into an earthing
three-slot-plus earth, wall receptacle on a separate
circuit. DO NOT OPERATE OTHER APPLIANCES
ON THE SAME CIRCUIT WHEN A DRYER IS
OPERATING.
CAUTION
If this appliance is supplied from a cord
extension set or an electrical portable
outlet device, the cord extension set or
electrical portable outlet device must be
positioned so that it is not subject to
splashing or ingress of moisture.
If the supply cord is damaged, it must be replaced by
the manufacturer, its special agent or similarly
qualified persons in order to avoid a hazard.
512691R4
W479
W563
© Copyright, Alliance Laundry Systems LLC – DO NOT COPY or TRANSMIT
1
2
3
4
10A
1
Lead-In Cord
2
Earth Screw
3
Lead-In Cord Plug
4
Earth
Figure 20
Installation
DRY2155N
DRY2155N
19
Advertisement
Table of Contents
