US Robotics 56K USB Modem User Manual page 74

+FNR—Negotiation Message Reporting Control Parameter
+FNR=<rpr>,<tpr>,<idr>,<nsr> is used to control the reporting of messages generated during Phase B
negotiations. Description of controls is shown in table below.
Result codes:
• OK if <rpr> = 0-1, <tpr> = 0-1,<idr> = 0-1, <nsr> = 0-1.
ERROR if <rpr> ≠ 0-1, <tpr> ≠ 0-1,<idr> ≠ 0-1, <nsr> ≠ 0-1.
•
Table 149. +FNR Valid Parameter Values
Label Values
RPR 00
01
TPR 0
1
IDR
0
1
NSR 0
1
+FNS—Report Nonstandard Setup (NSS) Frames
The +FNS:<NSS FIF string> response reports any received nonstandard setup frame, one response per
frame. FIF is the facsimile information field. The string is limited to 20 bytes.
Result codes:
• NA
Description
Receiver parameters are not reported. +FIS: and
+FTC: reports are suppressed.
Receiver parameters are reported. +FIS: and
+FTC: reports are generated.
Transmitter parameters are not reported. +FCS:
reports are suppressed.
Transmitter parameters are reported. +FCS:
reports are generated.
ID strings are not reported. +FTI:, +FCI:, and +FPI:
reports are suppressed.
ID strings are reported. +FTI:, +FCI:, and +FPI:
reports are generated.
Nonstandard frames are not reported. +FNF:,
+FNS:, and +FNC: reports are suppressed.
Nonstandard frames are reported. +FNF:, +FNS:,
and +FNC: reports are generated.
56K USB Modem
User Guide
Command Reference - 68