US Robotics 56K USB Modem User Manual page 70

+FHR—Report Received HDLC Frame
+FHR:<received HDLC frame octets> reports the HDLC data that was sent by the DCE.
Result codes:
• NA
+FHT—Report Transmitted HDLC frame
+FHT:<transmitted HDLC frame octets> reports the HDLC data that was received by the DCE.
Result codes:
+FIP—Initialize Facsimile Parameters
The +FIP command causes the DCE to initialize all Service Class 2.0 facsimile parameters to the
manufacturers determined default settings.
Result codes:
• NA
+FIS—Report Remote Capabilities
+FIS=<vr>,<br>,<wd>,<ln>,<df>,<ec>,<bf>,<st>,<jp> is used by DTE to sense DCE capabilities and
constrain if necessary (see +FCC valid parameter value table for valid value of each parameter).
Result codes:
• OK if <vr> = 00-FF, <br> = 00-0D,<wd> = 00-02, <ln> = 00-02, <df> = 00-03, <ec> = 00-01, <bf> = 00,
<st> = 00-07, <jp> = 00-FF.
ERROR if <vr> ≠ 00-FF, <br> ≠ 00-0D,<wd> ≠ 00-02, <ln> ≠ 00-02, <df> ≠ 00-03, <ec> ≠ 00-01, <bf> ≠
•
00, <st> ≠ 00-07, <jp> ≠ 00-FF.
+FKS—Session Termination Command
The +FKS command causes the DCE to terminate the session in an orderly manner.
Result codes:
• NA
+FLI—DCE Transmits Local ID String for TSI or CSI
The DTE sends the local ID string to the DCE using +FLI=<local ID string>. The DCE sends the ID string to
the remote station using the CSI or TSI frame. The syntax is as follows:
+FLI:<local ID string>.
Result codes:
• OK if < local ID string > has between 0 and 20 characters.
• ERROR if < local ID string > has more than 20 characters.
56K USB Modem
User Guide
Command Reference - 64