US Robotics 56K USB Modem User Manual page 73

+FMS=<value>—Minimum Phase C Speed Control
Use this command to limit the lowest negotiable speed for a session. The value is the same as the BR
parameter in the +FCC valid parameter table.
Result codes:
• OK if <value> = 0—5.
≠
• ERROR if <value>
Table 148. +FMS Commands
Command
+FMS=0 2400 bits/s (default)
+FMS=1 4800 bits/s
+FMS=2 7200 bits/s
+FMS=3 9600 bits/s
+FMS=4 12000 bits/s
+FMS=5 14400 bits/s
+FNC—Report Nonstandard Command (NSC) Frames
The +FNC:<NSC FIF string> response reports any received nonstandard command frame, one response
per frame. FIF is the facsimile information field.
Result codes:
• NA
+FND=<value>—Nonstandard Message Data Indication
If the DTE has negotiated to exchange a nonstandard message type with the remote facsimile, the DTE
must indicate this to the DCE prior to issuing the +FDT or +FDR command for the message data.
+FND=0, the message type is specified in DCS.
+FND=1, the message type is nonstandard. The DCE does not modify data on transmission or reception.
The DCE copy quality checking is disabled.
Result codes:
• OK if <value> = 0, 1.
ERROR if <value> ≠ 0, 1.
•
+FNF—Report Nonstandard Facilities (NSF) Frames
The +FNF:<NSF FIF string> response report any received nonstandard facilities frame, one response per
frame. FIF is the facsimile information field.
Result codes:
• NA
0—5.
Function
56K USB Modem
User Guide
Command Reference - 67