Skoda yeti Owner's Manual page 95

Removing/installing the carrier rails
Using the variable loading floor with a spare wheel
The variable loading floor makes it easier to handle bulky goods and creates an
even floor when the rear seat backrests are folded forward.
The maximum permissible load of the variable loading floor is 75 kg.
Removing/inserting variable loading floor
Fig. 111 Fold up / removal variable loading floor
›
To remove, grasp the variable loading floor on the handle
gether in the direction of arrow
›
Fold up the variable loading floor in direction of arrow
›
Pull on both sides of the locking levers in direction of arrow
›
Remove the variable loading floor in direction of arrow
Insertion takes place in reverse order.
Secure the variable loading floor in the raised position
and fold to-
A
» fig. 111.
1
.
2
.
3
.
4
Fig. 112
Secured loading floor in the
raised position
›
93 Fold up the hooks on the fastening strip in direction of arrow
page 89.
94
›
Fold up the variable loading floor behind the rear back backrests.
›
Fold down the hooks in direction of arrow
the stop.
›
Support the variable loading floor on the hooks folded downwards
Removing/installing the carrier rails
Fig. 113 Slacken check points/remove carrier rails
Removing
›
Slacken the check points
or a flat screwdriver.
›
Hold the carrier rail in the front area and remove by pulling in the direction
A
of arrow .
1
›
Hold the carrier rail in the rear area and loosen and remove by pulling in
A
the direction of arrow
2
Installing
›
Position the carrier rails on the sides of the luggage compartment.
›
Press both check points on each carrier rail
›
Check the attachment of the carrier rails by pulling it.
» fig. 103 on page 89 as far as
3
» fig. 113 on the carrier rails using the vehicle key
B
.
» fig. 113 up to the stop.
B
Transport of cargo
» fig. 103 on
1
» fig. 112.
93