Skoda yeti Owner's Manual page 130

Fig. 147 Locking the lock and removing the key/replacing the lock cap

Read and observe on page 126 first.
›
Grip the cap on the rear bumper
direction of the arrow and remove in the direction of the arrow
1
›
Pull off the cover for the mounting recess
direction of the arrow.
›
Adjust the ball rod to the ready position
›
Grip the ball rodfrom underneath
cess in arrow direction until you hear it click into place. The ball rod must
3
audibly snap into place » .
The handwheel » fig. 146 returns automatically and rests on the tow bar
C
» .
›
Lock the handwheel lock by turning the key
rection of the arrow to the stop, and remove the key in the direction of
4
the arrow .
5
›
Put the cap onto the handwheel lock in the direction of the arrow
E
›
Check the tow bar for proper attachment
WARNING
When attaching the tow bar, do not hold the handwheel by hand - risk of
■
injuring fingers!
Carefully remove the cap for the mounting recess - there is a risk of hand
■
injury!
128
Driving
» fig. 146 at the handle release in the
B A
» fig. 143 on page 126 in the
4
» page 127.
» fig. 146 and insert into the mounting re-
» fig. 147 to the left in the di-
D
» page 128.
Check proper mounting

Read and observe
Correctly secured ball head
The tow bar does not come off the mounting recess even after strong

.
2
"shaking".
The green marking

tow bar.
The steering wheel is tight against the ball rod.

The key is removed and the cap

Removing ball rod- Step 1
.
6
Fig. 149 Removing the lock cover/releasing the lock

Read and observe
No trailer or other accessory may be connected to the tow bar. We recommend
putting the protective cover onto the ball head before removing the ball rod.
Fig. 148
Correctly connected tow bar
on page 126 first.
» fig. 148
on the handwheel is located in the green box on the
A
attached to the lock.
C
on page 126 first.
