Skoda yeti Owner's Manual page 45

®
AdBlue range - drive distance in km which can be covered with the existing
®
AdBlue tank capacity and with the same driving style. If you drive more effi-
ciently this value can increase.
Distance driven - Distance driven since the memory was last cleared.
Average speed - Value constantly recalculated, for distance since last clearing
the memory. After erasing the memory, no data will appear for the first 300 m
driven.
Current Speed - Digital speedometer.
Oil temperatureif the temperature is lower than 50 °C or if there is a fault in
the system for checking the oil temperature, thesymbols are displayed.
Warning at when the preset speed is exceededallows the setting of a speed
limit where, if exceeded, an acoustic warning signal and a warning message
appears on the display of the instrument cluster.
Warning when exceeding the set speed
The system offers the option to set a speed limit beyond which an acoustic
warning signal will sound and the following warning message (MAXI DOT Dis-
play) and the symbol (Segment display) appears in the display of the instru-
ment cluster.
Adjust the speed limit while the vehicle is stationary
›
Select the menu item Speed warning at()  () and confirm.
›
Set the desired speed limit.
›
Confirm the set value, or wait several seconds; your settings will be saved
automatically.
Adjusting the speed limit while the vehicle is moving
›
Select the menu item Speed warning at () or () and confirm.
›
Drive at the desired speed.
›
Confirm the current speed as the speed limit.
The set speed limit can be manually adjusted later if needed.
Reset speed limit
›
Select the menu item Speed warning at () or  () and confirm.
›
By confirming the speed stored in the memory, the speed limit is reset.
The set driving mode remains stored even after switching the ignition on and
off.
Memory
Fig. 26
Multi-function display - memory display
The system stores data from the two memories described below, which are
then displayed at position » fig.
A
"1" - Single-trip memory
Driving data is stored from when the ignition is switched on to when it is
switched off. If the trip is continued within 2 hours after switching off the igni-
tion, new data will also flow into the calculation of the current driving informa-
tion.
If the trip is interrupted for more than 2 hours, the memory is automatically
erased.
"2" - Long-term memory
The memory gathers data from any number of individual journeys up to a total
of 19 hours and 59 minutes or 1999 kilometres driven (), and up to a total of
99 hours and 59 minutes or 9999 kilometres driven ().
The indicator is automatically set back to zero if one of the indicated values is
exceeded.
›
To choose the memory bank, confirm the selected indication again and se-
lect the desired memory.
›
To delete the memory bank of the chosen selection, hold down the button
confirming the selection.
The following driving data is stored in different memory banks.
▶
Average fuel consumption.
▶
Distance driven.
▶
Average speed.
▶
Driving time
26.
information system

43