Fuses And Light Bulbs; Fuses - Skoda yeti Owner's Manual

Attaching the windscreen wiper blade
›
Slide the windscreen wiper blade in the opposite direction to arrow
locks into place. Check that the windscreen wiper blade is correctly attached.
›
Fold the windscreen wiper arm back to the windscreen.
›
Turn on the ignition and press the lever in the direction of the arrow
» fig. 189.
Move the windscreen wiper arms into the home position.
Replacing the rear window wiper blade
Fig. 191 Changing the rear window wiper blade

Read and observe on page 167 first.
Removing the wiper blade
›
Lift the wiper arm» page 168from the window in the direction of arrow
» fig. 191.
›
Tilt the wiper blade to the stop in the same direction.
›
Grip the wiper arm and press securing latch
.
2
›
Remove the wiper blade in the direction of the arrow
Attaching the windscreen wiper blade
›
Slide the windscreen wiper blade in the opposite direction to arrow
locks into place. Check that the windscreen wiper blade is correctly attached.
›
Fold the windscreen wiper arm back to the windscreen.
168
Do-it-yourself
until it
3
1
down in the direction of arrow
A
.
3
until it
3

Fuses and light bulbs

Fuses


Introduction
This chapter contains information on the following subjects:
Fuses in the dashboard
Fuse arrangement in the dash panel
Fuses in the engine compartment
Fuse arrangement in the engine compartment
Individual electrical circuits are protected by fuses. A blown fuse is recognisa-
ble from the melted-through metal strip
WARNING
Always read and observe the warnings before completing any work in the
engine compartment » page 143.
CAUTION
Replace the faulty fuse with a new one of the same amperage.
■
If a newly inserted fuse again blows after a short time, then seek assistance
■
from a specialist garage.
"Do not repair" the fuses and do not replace them with stronger fuses -
■
There is a risk of fire and damage to another electrical system.
Notice
We recommend always carrying replacement fuses in the vehicle.
■
There can be several power consuming devices for one fuse. Multiple fuses
■
may exist for a single power consuming device.
Fig. 192
Blown fuse
» fig. 192.
169
169
170
170