Waste Container - Skoda yeti Owner's Manual

WARNING
Do not place anything on the dash panel. These objects might slide or fall
■
down when driving and may distract you from concentrating on the traffic –
There is a risk of an accident!
Make sure that while driving no objects can enter the driver's footwell -
■
There is a risk of an accident!
Stow all devices safely during the journey to prevent them from being
■
thrown around the interior in the event of a sudden braking manoeuvre or
an accident – There is a risk to life!
The devices may warm up during operation – There is a risk of injury or
■
fire!
Improper use of the power sockets and the electrical accessories can
■
cause fires, burns and other serious injuries.
The socket also works if the ignition is switched off. When leaving the ve-
■
hicle, never leave persons who are not completely independent, such as
children, unattended in the vehicle.
CAUTION
The sockets can only be used for the connection of approved electrical ac-
■
cessories with a total power consumption of up to 120 watts - otherwise there
is a risk of damage to the electrical system of the vehicle.
Connecting appliances when the engine is not running will drain the battery
■
of the vehicle!
Before switching the ignition on / off or before starting the engine, switch
■
off the devices which are connected to the sockets - there is a risk of damage
to the equipment due to voltage fluctuations.

Waste container

Fig. 82 Waste container: inserting and moving / opening
Fig. 83 Replace bags

Read and observe and
The waste container can be inserted into the slot in the door.
Insert waste container
›
Position the waste container at the front edge of the slot.
›
Push in the rear waste container in the direction of the arrow
›
Push the waste container as required in the direction of arrow
Remove the waste container
›
Remove the waste container away from the arrow
Open/close waste container
›
Lift the lid in the direction of arrow
Closing takes place in reverse order.
Replace bags
›
Remove the waste container from the slot.
›
Press the two locking lugs on the frame in the direction of arrow
›
Pull the bag downwards together with the frame in the direction of arrow
›
Remove the bag from the frame.
›
Pull the new bag through the frame and pull it over the frame in the direction
of arrow .
3
›
Place the bag with the frame in the direction of arrow
body, so that the two lugs audibly engage on the frame.
Notice
We recommend that you use 20x30 cm bags.
on page 76 first.
A
B
» fig. 82.
A
» fig. 82.
C
into the container
4
Useful features
» fig. 82.
.
» fig. 83.
1
.
2
81