Skoda yeti Owner's Manual page 50

Automatic connection
If the communication device has already had a connection with SmartGate,
then the connection is automatically restored under the following conditions.
The ignition is switched on.

Wi-Fi is switched on in the external device that is to be connected to.

The external device that is to be connected to stores the password re-

quired for the connection check.
Connection to SmartGate using direct Wi-Fi
This type of connection is intended for external devices running the Android
operating system.
Connection set-up
›
Switch on the ignition.
›
In the external device that is to be connected to, start the SmartGate appli-
cation.
›
In the application, change the connection type to Wi-Fi direct.
›
Then follow the instructions which are included in the SmartGate application.
The password for the connection to SmartGate _...
of the vehicle identification number
With SmartGate, a maximum of two external devices can be connected simul-
taneously using Wi-Fi direct, with as many launched ŠKODA applications as re-
quired.
If you want to connect to SmartGate in a different vehicle, you must make a
new connection in the SmartGate application.
Disconnection
Disconnection is possible in one of the following ways.
›
Switch off the ignition for longer than 5 seconds (for vehicles with a starter
button, switch off the engine and open the driver's door).
›
End the connection in the SmartGate application.
›
Switch off Wi-Fi in the connected external device.
Automatic connection
If the external device once had a connection with SmartGate, then the connec-
tion is automatically restored after the ignition is started.
1)
At the position ... the last six symbols of the vehicle identification number are displayed.
2)
If the button "Reboot" is not displayed, then the Web browser display must be restored manually.
48
Using the system
includes the last six digits
1)
» page 48.
SmartGate web interface
In the SmartGateInterface -SmartGateParameters can be set.
The following address must be entered in the web browser of the external de-
vice that is connected with SmartGate.
HTTP://192.168.123.1
The setting changes are only effective after pressing the buttons "Save" →
"Reboot".
Password/PIN code
The password for the Wi-Fi connection preset by the factory is the complete
vehicle identification number (entered in upper case); the PIN code for the Wi-
Fi direct connection is the last 6 digits of the vehicle identification number.
After changing the password/PIN, the connection to SmartGate must be re-es-
tablished on the external device to be connected using the new password or
new PIN code.
Change password for the Wi-Fi connection
›
Open the SmartGate web interface
›
In the menu item "WPA / WPA2 key:" enter the new password (8 to 63 alpha-
numeric, special, lower and upper case characters).
›
Confirm he password by pressing the button "Save".
›
Restart SmartGate by tapping on the interface "Reboot"
PIN code change for the Wi-Fi Direct connection
›
Open the SmartGate web interface
›
In the menu item "WiFi Direct PIN:" Enter the new PIN code (6 digits).
›
Confirm the PIN code change by tapping on the interface "Save".
›
Restart SmartGate by tapping on the interface "Reboot"
Notice
If you have forgotten your password for connecting to SmartGate, SmartGate
must be reset to factory settings in a specialised workshop.
» page 48, SmartGate web interface.
.
2)
» page 48, SmartGate web interface.
.
2)