Selector lever-emergency unlocking
Fig. 188 Remove / release the selector lever
›
Firmly apply the handbrake.
›
Insert a flat-head screwdriver or similar tool into the gap in the arrow area
» fig. 188
and loosen the cover in the direct of arrow
›
Press on the yellow plastic part in the direction of arrow
press the lock button in the selector lever handle and put the lever in posi-
tion N.
If the selector lever is moved again to position P, it is once again blocked.
CAUTION
Make sure that when lifting the cover no parts are damaged by the screwdriver
in the selector lever environment.
Replacing windscreen wiper blades
Introduction
This chapter contains information on the following subjects:
Replacing the windscreen wiper blades
Replacing the rear window wiper blade
WARNING
Replace the windscreen wiper blades once or twice a year for safety rea-
sons.
Replacing the windscreen wiper blades
1
.
2
, simultaneously
3
Fig. 190 Changing the front windscreen wiper blade
Before replacing the windscreen wiper blades, close the bonnet and put the
windscreen wiper arms into the service position.
Setting the service position
›
Switch the ignition on and off again.
›
Push the lever in the direction of
167
for approximately 2 seconds.
168
Removing the wiper blade
›
Lift the wiper arm from the window in the direction of
›
Tilt the wiper blade to the stop in the same direction.
›
Grip the wiper arm and press securing latch
2
›
Remove the wiper blade in the direction of the arrow
Read and observe
on page 167 first.
arrow» fig.
.
Emergency equipment, and self-help
Fig. 189
Setting the service position for
the wiper arms
189within 10 seconds and hold
» fig.
190.
1
down in the direction of arrow
A
.
3
167