Networking Setup; Bios Settings; Connecting The Networking Cable - Avery Dennison snap 500 Operator's And Service Manual

User's Manual—SNAP™ 500 Gen 1 and Gen 2

3.7 Networking Setup

3.7.1 BIOS settings

3.7.2 Connecting the networking cable

Motherboard: Do not use.
Classification: Avery Dennison - Public
The recommended network setup is through a Static IP address. Once an IP
address has been set, the operator can then view and change the printer settings
through the SNAP webserver using a browser on any computer on the network.
Most of the functionality of the VCP in PCMate is available through the web
server. See section 5.4 for the webserver.
The Advantech motherboard requires no updates to the BIOS.
BCM motherboard requires the following updates to use the Ethernet port on the
printer's motherboard.

Connect a video monitor to the video port and a keyboard to the PS/2
connector on the printer.

Restart the printer and press the "DEL" key to cause the printer to enter
the CMOS Setup Utility.

Arrow down to Integrated Peripherals, press Enter

For GbE Controller set to ENABLE.

For 82573 Controller set to ENABLE

Press F10, the Enter (OK) to save.

Restart the printer.
Older motherboards:
Network Interface Card
25