Cut / Stack - Avery Dennison snap 500 Operator's And Service Manual

User's Manual—SNAP™ 500 Gen 1 and Gen 2

9.4 Cut / Stack

Problem
Machine fails to cut
labels (the rotary
knife does not rotate).
The stacker platform
fails to run.
Labels will not stack.
Knife does not cut
completely through.
Knife will not cut.

Classification: Avery Dennison - Public
Probable Cause
1) The knife is disabled.
2) Cut count is set to "0" in the
Design File.
1) The stacker cable is
disconnected.
1) Stacker is not operating.
2) Stacker position on the
machine too high or too low.
3) Incorrect position platform
bed angle.
4) Static brush height too high
or too low
1) Knife blade shear is
misaligned.
1) Knife blades are dull.
IF THE RECOMMENDED CORRECTIVE ACTIONS DO NOT
RESOLVE THE PROBLEM (S), CONTACT YOUR LOCAL
AVERY DENNISON REPRESENTATIVE.
Corrective Action
1) Enable the knife in the setup menu via the
Remote Control / Display Module section
7.0, or through the Virtual Control / Display
in PCMate Platinum section 8.0.
1) Refer to the PCMate software manual.
1) Power off the machine and insert the
stacker cable in the stacker port.
1) Be sure the nip roller is free to rotate.
1) Move the toggle switch to the opposite
position.
1) Use the pull pin to change the platform
angle.
1) Adjust height of static brush on exit nip
rollers.
1) Refer to section 6.4, Knife Shear
Adjustment.
1) Refer to section 5.4.1, Removing and
Replacing the Knife assembly.
89