Furuno FCR-2119-BB Operation Manual page 28

1. OPERATIONAL OVERVIEW
Control
Status LED
Rotary control
EBL1, EBL2
ALARM ACK
InstantAccess
knob
ESC
BRILL
A/C RAIN
A/C SEA
GAIN
HL OFF
OFFSET EBL
MODE
STBY TX
OFF CENTER
CU/TM RESET
INDEX LINE
MENU
1-2
Turns the system on or off. (With a FURUNO monitor unit, the monitor is also
turned on or off with this switch.)
The color and state of the LED change according to system or alert status.
Green, lighting: Normal operation status; no alerts generated.
Green, flashing: The heater on the CPU board is on, because ambient tem-
perature is not at least 0°C. The heater takes about two minutes to warm the
equipment. The LED lights green after the heater goes off.
Red, lighting: Acknowledged alert or SYSTEM FAIL. SYSTEM FAIL occurs
when there is trouble in the Processor Unit or communication failure between
the Processor Unit and a Control Unit. Each Control Unit detects trouble and
its lamp flashes in red and the buzzer sounds. If this condition occurs at the
No. 1 Control Unit, the SYSTEM FAIL signal is output.
Red, flashing: Unacknowledged alert or SYSTEM FAIL.
Rotary control: Rotates the active EBL.
EBL1, EBL2: Activates or deactivates the respective EBL.
• Silences the aural alarm.
• Acknowledges unacknowledged alert.
Selects the buttons on the InstantAccess bar™.
Goes back one step in current operating sequence on the InstantAccess
bar™.
Rotate: Adjusts the brilliance of the display (FURUNO-supplied monitor only).
Push: Selects a color palette.
Rotate: Suppresses rain clutter.
Push: Toggles between manual and automatic rain clutter adjustment.
Rotate: Suppresses sea clutter.
Push: Toggles between manual and automatic sea clutter adjustment.
Adjusts the sensitivity of the radar receiver.
• Temporarily erases everything but radar echoes when held down.
• Enters the numeric 1.
• Selects like-numbered menu item.
• Activates or deactivates the offset EBL.
• Enters the numeric 2.
• Selects like-numbered menu item.
• Selects a presentation mode.
• Enters the numeric 3.
• Selects like-numbered menu item.
Toggles the radar between standby and TX.
• Re-centers radar position at the cursor location.
• Enters the numeric 4.
• Selects like-numbered menu item.
• Course-up: Resets heading line to 000°.
• True motion: Moves own ship position 75% of the radius in stern direction.
• Enters the numeric 5.
• Selects like-numbered menu item.
• Selects an index line (in the PI line box).
• Long press to activate or deactivate selected index line.
• Enters the numeric 6.
• Selects like-numbered menu item.
Opens, closes the menu.
Description