Manual Updates And Synchronization - Furuno FCR-2119-BB Operation Manual

Note 1: In normal operation do not disable synchronization. If you accidentally disable
synchronization, try to synchronize by clicking the [Enable Sync] button. If that does
not work, reset the power of all units selected for synchronization then click the [Urge
Sync] button to synchronize.
Note 2: With synchronization disabled, the message "Synchronization disabled" may
appear twice when installing a license. This does not affect installation of a license.
[Urge Sync] button: Does immediate synchronization. The confirmation message "At-
tention: Chart data in other units will be overwritten by this unit. Do you wish to contin-
ue?" appears. Click the [OK] button to synchronize. If synchronization is not
successful, restart applicable units and try again.
[Reset Status] button: Reset synchronization status to recover from synchronization
status conflict. The confirmation message "Attention: Do you want to reset sync sta-
tus? This unit may be synchronized from the other unit." appears. Click the [OK] button
to reset.
7.21.3

Manual updates and synchronization

If you are synchronizing multiple units (FMD-3x00, FCR-2xx9 or FAR-3xx0) while
manual updating is being done on one of the units, the message "File not found" may
appear, meaning the manual update data was deleted. If this occurs, follow the pro-
cedure below to synchronize the FAR-3xx0 units. The procedure uses CRA001 and
CRA002 as an example.
1. At the CRA001, get into the Chart maintenance mode, then click [System] and
[Sync Config] on the InstantAccess bar™.
2. Add CRA002 to [Grouped with This Unit] then click the [Save] button.
3. Reset the power on the CRA001 and CRA002.
4. At the CRA001, get into the Chart maintenance mode, then click the [System] and
[Sync Status] buttons on InstantAccess bar™ to show the [Sync Status] dialog
box.
5. Click the [Urge Sync] button to synchronize charts between CRA001 and
CRA002.
6. To confirm synchronization, do as follows:
1) At the CRA001, get into the Voyage navigation mode, then click the [Manual
Update] button on the InstantAccess bar™ to open the [Manual Update] dialog
box.
2) Click the [Planning] tab followed by the [Add] button.
3) Insert an object at the CRA001.
4) At the CRA002, move the cursor or change the chart scale. Confirm that the
chart is updated.
7. HOW TO MANAGE CHARTS
7-31