Table of Contents
Advertisement
2. Click the [C-MAP] tab to the show the [Licenses] dialog box for C-MAP.
3. Click the [C-MAP Setup] button.
4. The confirmation message "Attention: C-MAP eToken will be initialized. Do you
wish to continue?" appears. Click the [OK] button to continue and register the eTo-
ken.
Note 1: "CMAP: No connection to eToken" disappears from the Permanent warning
box after completion of the registration.
Note 2: You can show your C-MAP system ID by clicking the [C-MAP SystemID] but-
ton on the [Licenses] dialog box for C-MAP.
7.5.2
How to install the C-MAP database
When you install the C-MAP database from a medium, all data is saved to the SSD.
Note 1: To synchronize chart data between multiple units (FMD-3x00, FAR-3xx0 or
FCR-2xx9), group the units (see section 7.21.1) you wish to synchronize before you
install the charts. If the group setting is done after chart installation, the units will not
synchronize. If, after setting the group and installing the charts, the charts are not syn-
chronized, delete, then reinstall the chart.
Note 2: The installation of a chart cannot be cancelled while it is in progress. If you get
an error message, try to install the charts again.
Note 3: The C-MAP database in the units selected for synchronization are synchro-
nized at the successful completion of the database installation.
1. Insert the medium that contains the C-MAP database.
2. Get into the Chart maintenance mode then click the [AUTO Load] button on the
InstantAccess bar™.
3. The [Install chart data] window appears and shows the percentage of completion,
with digital and analog indications.
7. HOW TO MANAGE CHARTS
7-7
Hide quick links:
Advertisement
Table of Contents
Troubleshooting
