Configuring – Power; Restart To Image - GE MDS ORBIT MCR Technical Manual


Percent Complete – The percentage complete for the operation
To view the status of the copy process in the CLI, ensure the CLI is in operational mode and then follow
the example below:
> show system firmware copy-image-status
system firmware copy-image-status state complete
system firmware copy-image-status detailed-message "Successfully copied host firmware
image"
system firmware copy-image-status size 38043384
system firmware copy-image-status bytes-transferred 38043384
system firmware copy-image-status percent-complete 100
Configuring – Power
To restart the device to a specified firmware image, navigate to the Power section and select the
appropriate image (1 or 2) to restart into. Once an image is selected, click on the Restart to selected
button to begin.
Allow approximately 2 minutes for the unit to complete the restarting process and refresh the screen.
To initiate a restart from the CLI, ensure the CLI is in operational mode and then follow the examples
below to restart into the desired firmware image.
> request system power restart inactive
> request system power restart active
> request system power restart image 1
> request system power restart version 4.0.2
File Servers
External file servers can be pre-configured in the CLI so that the configuration can easily be referenced in
other services without the need to re-enter the information. File Server Configurations can be used for
reprogramming, downloading certificates, configuration script import and export and sending support
bundles for debugging.
The following shows how to add a file server configuration named "GE File Server 1":
% set file-servers GE_file_server_1 tftp address 192.168.1.10
% commit
> show configuration file-servers
file-servers GE_file_server_1 {
tftp {
address 192.168.1.10;
}
}
178
Figure 3-93. Restart to Image
MDS Orbit MCR/ECR Technical Manual MDS 05-6632A01, Rev. F