Snmp Agent Settings - GE MDS ORBIT MCR Technical Manual


Agent settings:

Enabled – If checked (true) , the SNMP support is available.

Ipv 4 Bind Ips – Restrict the server to only listen for connections on the specified IPv4
addresses. If not specified, the server will listen on all IPv4 addresses.

Ipv 6 Bind Ips – Restrict the server to only listen for connections on the specified IPv6
addresses. If not specified, the server will listen on all IPv6 addresses.

Port – UDP protocol port to be used for communication Valid values: 0—65535 Default: 161

Max Message Size – The privacy mode to use on this interface.

Debug Enabled – The privacy mode to use on this interface

Agent Version settings:

V 1 – SNMP version 1: Only requires a plain-text community, with 32 bit counters, and
minimal security.

V 2C – SNMP version 2 C (DEFAULT) : V 2c is basically equivalent to version 1, except it
adds support for 64 bit counters.

V 3 - SNMP version 3: adds both encryption and authentication, which can be used or in
combination.

Agent Engine settings:

Engine ID (submenu) - Local SNMP engine's administratively-unique identifier. Click on the
Engine ID and set/verify the parameters.
304
Figure 3-225. SNMP Agent Settings
MDS Orbit MCR/ECR Technical Manual MDS 05-6632A01, Rev. F