GE MDS ORBIT MCR Technical Manual page 219

- Echo Request
- Echo Reply
- Address Mask Request
- Address Mask Reply
- Parameter Problem
- Redirect
- Router Advertisement
- Router Solicitation
- Source Quench
- Time Exceeded
- Timestamp Request
- Timestamp Reply.

Source IP – Apply rule to traffic that originates at a specific source address or addresses.

Mode – Address, Address Range, Address Set, Not Address, Not Address Range, Not Address
Set.
All – Apply rule regardless of source address.
-
- Address - Apply rule to a specific source address and prefix.
Address Range – Apply rule to a range of source addresses.
-
Address Set – Apply rule to a non-contiguous set of source addresses.
-
- Not Address - Apply rule to traffic that does not originate from a specific source address
and prefix.
Not Address Range – Apply rule to traffic that does not originate from a source address
-
range.
Not Address Set – Apply rule to traffic that does not originate from a non-contiguous set
-
of source addresses.

Source Port – Apply rule to traffic that originates at a specific source port. This option is available
only with protocols SCTP, TCP, and UDP.

Services – Services, Port Range, Not Services, Not Port Range.

Services – Apply rule to traffic originating from one or more designated well-known service
source ports. The services must be specified by name and separated by commas.
Port Range – Apply rule to traffic originating from a specific source port or set of ports.
-
Not Services – Apply rule to traffic that does not originate from one or more designated
-
well-known service source ports. The services must be specified by name and separated
by commas.
Not Port Range – Apply rule to traffic that does not originate from a specific source port
-
or set of ports.

Destination IP – Apply rule to traffic intended for a specific destination address or addresses.

Mode – Address, Address Range, Address Set, Not Address, Not Address Range, Not Address
Set.
All – Apply rule regardless of destination address.
-
- Address - Apply rule to a specific destination address and prefix.
Address Range – Apply rule to a range of destination addresses.
-
Address Set – Apply rule to a non-contiguous set of destination addresses.
-
MDS 05-6632A01, Rev. F MDS Orbit MCR/ECR Technical Manual 219