Dog trace d-fence 6th SENSE User Manual page 20

performance of the collar unit and whether or not the dog will receive
the stimulation impulses. A loose collar can also result in skin irritations.
The collar should be tight enough to fit two fingers between the collar
and your dog's neck, but not so tight that it restricts your dog's breathing.
It is possible to check the current mode of the receiver. Place the magnet
■
to a target marked on the receiver. Remove it after one second. The
receiver emits certain number of beeps indicating the current mode
(1-9).
It is possible to check that your invisible fence system is operating
■
correctly any time using the test discharge lamp (see the section Zones
setting).
Check the condition of the receiver battery regularly. Low battery can
■
affect correct operation of the system.
Before each use make sure the contact points are properly tighten
■
(by hand).
Do not install the antenna wire near the electrical cable, telephone
■
cable or television cable. If necessary to place the antenna wire close to
electrical cables avoid parallel running. It is best to cross the cables at
right angles to minimise any signal interruption to the point of crossing
only.
Safety features
Antenna wire interruption warning - if the antenna wire is interrupted or
disconnected, the transmitter starts to emit beep sounds and
will show on display.
Warning zone evacuation - after approximately 8 seconds of continuous
presence in the warning zone, the dog will be warned to leave the zone by
one short stimulation impulse. The cycle will be repeated after 8 seconds
until the dog leaves the warning zone.
Correction zone evacuation - if the dog remains in the correction zone
for more than 10 seconds the d-fence receiver stops emitting stimulation
impulses.
Caution
Keep away from children.
■
Do not leave the device in or around a high temperature heat source.
■
Protect the receiver from water intrusion. (Check the seal and the screws
■
tightness.)
20
symbol