Now you can plug in the antenna connector with an antenna loop into
■
the antenna socket transmitter unit.
Zones settings
The width of the warning and the correction zone can be set easily on
the transmitter unit. Both zones are independent of each other making it
possible to set either the warning zone
or the correction zone. Both zones have
range settings from 0 to a minimum 7 m.
Maximum width depends on the length
and the cross section of the antenna wire.
We recommend the use of the test
discharge lamp to set the zones width.
Place the test discharge lamp in contact
with each of the contact points as shown
in the picture (before doing so, make
sure that the device is not active - remove the battery from the receiver or
switch the transmitter unit off ).
Inset the battery into the receiver and switch the transmitter unit on by
■
pressing the
Set the receiver in the mode 1 - 8 (see the section Stimulation Impulse
■
Setting)
From Main menu select Zones Settings. If the antenna wire is incorrectly
■
connected or interrupted, the unit will beep and
displayed on the screen.
The widths of warning and correction zone are set by default to value 0.
■
Pressing ENTER in the Zones Settings menu moves the focus on the
■
screen to the Warning zone setting.
Select the distance where you want to define the boundary of the
■
warning zone, hold the receiver with the sign "d-fence" towards the
antenna wire about 30 cm above the ground or as high as where the dog
wears the receiver. Adjust the zone setting (0 - 600) on the transmitter
unit by pressing the
sound signals.
Press ENTER to confirm your settings and to move focus to Correction
■
zone setting.
Select the distance where you want to define the boundary of the
■
correction zone, hold the receiver with the sign "d-fence" towards the
16
button.
buttons until the receiver emits a warning
symbol will be