Antenna wire indicator
The antenna wire indicator at the left bottom corner of the screen displays
the status of the antenna wire.
-
Antenna wire is connected and uninterrupted.
-
Antenna wire is disconnected, interrupted or transmitter
unit calibration was performed by mistake while antenna
wire connected.
Other transmitter unit functions
Faults – Select Faults in the Main menu to display the current status of
■
the installed loop.
Measuring – The menu item Measuring contains useful service
■
information. It is also possible to calibrate a transmitter as required for
the correct loop measurement. The device is already factory calibrated
and the recalibration is necessary only in exceptional cases after the
service agreement (in menu Measuring, press ENTER button, disconnect
the antenna connector with the loop, press ENTER again and reconnect
the antenna connector to the socket). Never calibrate when the antenna
connector is connected.
Configuration – In menu Configuration, press ENTER to set the display
■
contrast (0 – 20).
Quick start guide – Brief instruction and guide for installation.
■
Display backlight – Turns off automatically after more than 40 seconds
■
of inactivity. Reactivate the display backlight by pressing any button.
18