Setting up the transmitter unit for a short or a long installation of an
antenna wire.
d-fence 6th SENSE - 2
transmitter unit power, which is generated into the antenna wire. This
function allows a fine setting of warning and correction zone for a short
installation (up to 400 m wire installation) and also for a long installation
(above 400 m wire installation). The newly purchased transmitter unit is
factory pre-set for the installation up to 400 m. When your installation is
longer, it is necessary to make the following settings.
Setting process:
Press MENU to enter the Main menu, by pressing
■
select Configuration, press ENTER to confirm your settings.
By pressing ENTER button choose Loop.
■
If your antenna wire installation is shorter than 400 m, select by pressing
■
buttons UP TO 400 m. If your antenna wire installation is
longer than 400 m, select OVER 400 m.
Use MENU button to return to the Main menu.
■
Important: In the Main menu – Zones settings – is the current setting
indicated by:
- installation up to 400 m
- installation over 400 m
Important: The loop of the transmitter unit needs to be calibrated after
each adjustment of the antenna wire installation length.
Calibration of the loop:
In the Main menu, select Measuring.
■
Disconnect the antenna connector with the installed loop (antenna
■
wire).
Press ENTER.
■
Check that you have disconnected the antenna connector from the
■
transmitter unit.
Press ENTER.
■
In the bottom line you will see a confirmation „Calibration successful!"
■
generation enables you to switch over the
nd
buttons
15