Dog trace d-fence 6th SENSE User Manual page 10

The following table shows different modes of the receiver. The intensity
level of stimulation impulse must be set according to the size, sensitivity
and reaction of each dog.
Mode Number of beeps
1
2
3
4
5
6
7
8
9
Note: The receiver is set in mode 1 by default.
Choosing the contact points
The stimulation is delivered through the receiver contact points. Two
different series of contact points are supplied. The length of the contact
points must be sufficient to have proper contact with the dog's skin,
enabling the device to operate correctly. If you have a short-haired dog
use the short 12 mm contact points, if you have a long-haired dog replace
them with the longer 17 mm contact points supplied with the kit. Before
installing contact points, take out the battery from receiver or turn off
the transmitter unit. Carefully tighten them manually (do not use a key).
Note: It is possible to purchase 21 mm long contact pints for
long-haired dogs.
10
1
2
3
4
5
6
7
8
9
Stimulation impulse level
low
high
ISIT function