Advanced Operation Mode - Eaton S611 User Manual

Advanced Operation Mode

Code Parameter
P.00 Device Address Port
P.01 Modbus Baud Rate Port A
P.02 Modbus Parity Port A
P.03 Device Address Port B
P.04 Modbus Baud Rate Port B
P.05 Modbus Parity Port B
P.06 User Interface Edit Lock
P.07 User Display Parameter
P.08 Configuration Reset
Minimum Maximum
1 254
0 7
0 2
1 254
0 7
0 2
0 1
0 10
N/A N/A
S611 Soft Starter MN03902011E—May 2012 www.eaton.com
www.comoso.com
Default Notes
1 Port A—Top cover port
4 0 = 1200
1 = 2400
2 = 4800
3 = 9600
4 = 19200
5 = 38400
6 = 57600
7 = 115200
0 0 = Even (1 stop bit)
1 = Odd (1 stop bit)
2 = No parity (2 stop bits)
3 = Even (2 stop bits)
4 = Odd (2 stop bits)
5 = No parity (1 stop bit)
1 Port B —Hardwire port
4 0 = 1200
1 = 2400
2 = 4800
3 = 9600
4 = 19200
5 = 38400
6 = 57600
7 = 115200
0 0 = Even (1 stop bit)
1 = Odd (1 stop bit)
2 = No parity (2 stop bits)
3 = Even (2 stop bits)
4 = Odd (2 stop bits)
5 = No parity (1 stop bit)
0 0 = UIM editing enabled (unlocked)
1 = UIM editing disabled (locked)
This is the only parameter that can be
edited when locked
0 Value displayed in TC LED
0 = Thermal capacity (%)
1 = Power factor
2 = Line frequency
3 = Residual ground current
4 = Voltage imbalance (%)
5 = Current imbalance (%)
6 = Run time
7 = Average pole temperature
8 = Pole temp A phase
9 = Pole temp B phase
10 = Pole temp C phase
0 1 = Power cycle
2 = Restore factory default parameters
41