Make A Copy Of A Specific Area Of An Original - Canon Océ PlotWave 450 Operation Manual

Make a copy of a specific area of an original

Introduction
You can make a copy of a specific area of an original. Use the option [Remove strip] to copy a
specific area.
NOTE
For more information on the cut size settings, see
Procedure
1. Feed the original face up and centered on the original feeding table.
2. Tap the copy tile. A window with a list of presets opens.
3. Tap [Show all settings]. A list with settings opens.
4. Tap [Remove strip] under the [Layout] preset.
.
The [Top] strip
5. Select [Top], [Bottom], [Left], or [Right], and define the values for your specific area.
6. Make your settings and tap [OK].
7. Tap [Positioning] and then [Alignment].
8. Select [Center] from the list and tap [OK].
9. Define the number of copies and tap the green button.
The [Bottom] strip
Make a copy of a specific area of an original
Preset category:Layout on page
The [Left] strip
Chapter 4 - Use the Printing System
176.
The [Right] strip
187