Set The Link Speed And Duplex Mode - Canon Océ PlotWave 450 Operation Manual

Hide thumbs Also See for Océ PlotWave 450:
Table of Contents

Advertisement

Set the link speed and duplex mode

Set the link speed and duplex mode
Introduction
Use Océ Express WebTools to set the transmission speed and duplex mode for your network
adapter.
Before you begin
NOTE
The list of values you can select depends on the network card type.
Procedure
1. Open the [Configuration] - [Connectivity] tab.
2. Click on [Edit] in the [Network adapter] section or click on the [Link speed and duplex mode]
setting.
3. Select the value. [Automatic detection] is default.
4. Click on [Ok] to confirm or [Cancel] to reject your entries.
76
Chapter 3 - Define your Workflow with Océ Express WebTools

Advertisement

Table of Contents
loading

This manual is also suitable for:

Océ plotwave 550

Table of Contents