Siemens PM240-2 Hardware Installation Manual page 47

Terminal arrangement
Figure 5-7
Connecting DC link or braking resistor
You can use rubber cable glands when connecting the DC link and braking resistor.
A cable gland is already integrated to connect the braking resistor. For the DC link
connection, open the knockout opening and insert the cable gland.
Using a sharp knife, cut the cap of the cable gland corresponding to the diameter of your
cable and establish the connections.
Power Module PM240-2
Hardware Installation Manual, 12/2015, A5E33294624B AD
Line and motor connection PM240-2, FSF
Connecting-up
5.1 Line and motor connection
47