Dimension Drawings And Drilling Dimensions For Pt Power Modules - Siemens PM240-2 Hardware Installation Manual

Installing/mounting
4.3 Mounting the Power Modules
Note
Brake relay
If you are using a brake relay to control a motor brake, then mount the brake relay at the rear
of the lower shield plate before you attach the shield module to the inverter. See also
Mounting and connecting the brake relay (Page 117)
If you are using an inverter with integrated line filter, then you must mount the shield module
as described below.
Procedure
Proceed as follows to mount the shield module:
1. Attach the EMC connecting bracket to the shield plate
2. Screw the shield module to the inverter
You have correctly mounted the shield module.
4.3.5

Dimension drawings and drilling dimensions for PT Power Modules

Table 4- 3
Frame size
FSA
FSB
FSC
The Power Modules can be mounted side-by-side. For tolerance reasons, we recommend a lateral
1)
clearance of 1 mm.
Wall thickness of the control cabinet ≤ 3.5 mm
2)
32
Mounting dimensions
Width Height (mm)
1)
(mm)
126 238
154 345
200 411
①
.
②
using three screws, as shown in the diagram.
Depth (mm)
2)
with shield
plate
322 171
430 171
500 171
Hardware Installation Manual, 12/2015, A5E33294624B AD
T1 T2
117.7 53.1
117.7 53.1
117.7 53.1
Power Module PM240-2