Hydraulic Brake System - Arctic Cat HDX CREW 2017 Service Manual

PR920
Move the shift lever all the way back. The letter L should
illuminate on the LCD gauge.
PR921
If either park or low range cannot be reached, the shift
cable must be adjusted.
ADJUSTING SHIFT CABLE
1. Place the transmission in park; then tilt the cargo
box.
2. Make sure the shift lever is in park; then remove the
E-clip securing the cable end to the shift arm stud.
HDX251
3. Loosen nuts (A) and (B) and adjust the cable housing
to align the shift cable end to the shift arm stud.
HDX261B
4. Install the E-clip; then tighten the nuts (A) and (B) to
8 ft-lb.
5. Check each gear shift position for proper gear selection
and make sure the proper icon illuminates on the LCD.

Hydraulic Brake System

NOTE: This ROV is equipped with hydraulic

brakes at all four wheels.
CHECKING/BLEEDING
The hydraulic brake system has been filled and bled at
the factory.
1. With the master cylinder in a level position, check
the fluid level in the reservoir. If the level in the res-
ervoir is not above the MIN, add DOT 4 brake fluid.
PR095
2. Depress the brake pedal several times to check for a
firm brake. If the brake is not firm, the system must
be bled. To bleed the brake system, use the following
procedure.
A. Remove the cover and fill the reservoir with DOT 4
brake fluid; then install and secure the cover.
B. Slowly depress the brake pedal several times.
C. Install one end of a clear hose onto the RIGHT
REAR bleeder screw and direct the other end into a
container; then while holding slight pressure on the
brake pedal, open the bleeder screw and watch for air
bubbles. Close the bleeder screw before releasing the
brake pedal. Repeat this procedure until no air bub-
bles are present.
13