Hydraulic Brake System - Arctic Cat HDX 700 2017 Service Manual

PR920
Move the shift lever all the way back. The letter L should
illuminate on the LCD gauge.
PR921
If either park or low range cannot be reached, the shift
cable must be adjusted.
ADJUSTING SHIFT CABLE
1. Place the transmission in park; then tilt the cargo
box.
2. Make sure the shift lever is in park; then remove the
E-clip securing the cable end to the shift arm stud.
700
HDX251
500
HDX254
3. Loosen nuts (A) and (B) and adjust the cable housing
to align the shift cable end to the shift arm stud.
HDX261B
4. Install the E-clip; then tighten the nuts (A) and (B) to
8 ft-lb.
5. Check each gear shift position for proper gear selection
and make sure the proper icon illuminates on the LCD.

Hydraulic Brake System

NOTE: This ROV is equipped with hydraulic

brakes at all four wheels.
CHECKING/BLEEDING
The hydraulic brake system has been filled and bled at
the factory.
1. With the master cylinder in a level position, check
the fluid level in the reservoir. If the level in the res-
ervoir is not above the MIN, add DOT 4 brake fluid.
PR095
13