Servicing Right-Side Components - Arctic Cat HDX CREW 2017 Service Manual

CC606
11. Using an impact wrench, remove the cap screws
securing the final drive carrier bearing housing (D);
then remove the housing and account for two align-
ment pins.
CD999
12. Remove the snap ring securing the oil pump driven
gear (A); then remove the gear noting the direction
of the sides of the gear for installing purposes.
Account for a pin and a washer.
CD984
CD895A
70
13. Using an impact driver, remove the three torx-head
screws securing the oil pump; then remove the
pump.
CD988
Servicing Right-Side
Components
INSPECTING CENTRIFUGAL CLUTCH
SHOE
1. Inspect the clutch shoes for uneven wear, chips,
cracks, or discoloration. If any shoe is damaged,
replace the complete set.
2. Inspect the clutch shoes for wear or damage. If any
shoe is worn to the bottom of the groove, replace the
clutch assembly.
ATV1014
INSPECTING CLUTCH HOUSING
1. Inspect the clutch housing for burns, grooving,
cracks, or uneven wear.
2. If the housing is damaged in any way, the housing
must be replaced.
INSPECTING PRIMARY
ONE-WAY DRIVE
1. Insert the drive into the clutch housing.
2. Rotate the inner race by hand and verify the inner
race rotates only one direction.
3. If the inner race is locked in place or rotates both
directions, the drive assembly must be replaced.