Troubleshooting - Arctic Cat HDX CREW 2017 Service Manual

Installing
1. Place the thermostat with seal into the thermostat
housing; then secure the thermostat housing to the
cylinder head with the two cap screws.
CAUTION
When installing the thermostat, make sure the bleed
holes are straight up and down or air will remain
trapped causing engine damage due to overheating.

Troubleshooting

Problem: Starting impaired
Condition
1. Gas contaminated
Problem: Idling or low speed impaired
Condition
1. TPS out of adjustment
Problem: Medium or high speed impaired
Condition
1. High RPM "cut out" against RPM limiter
94
PR281A
2. Fill the cooling system with the recommended
amount of antifreeze. Check for leakage.
WATER PUMP
NOTE: The water pump is a non-serviceable com-

ponent. It must be replaced as an assembly (see
Removing Left-Side Components).
Remedy
1. Drain gas tank and fill with clean gas
Remedy
1. Adjust TPS
Remedy
1. Decrease RPM speed