Shift Cable - Arctic Cat HDX CREW 2017 Service Manual

3. Remove the cap screw and lock nut securing the shift
lever to bottom pivot location (underneath the dash-
board). Slide the shift lever down and out. Discard
the lock nut.
PR924A
INSTALLING
1. Slide the shift lever up through the opening; then
secure to the pivot using the existing cap screw and
new lock nut.
2. Secure the shift lever to the shift cable using the
existing cap screw and a new lock nut.
3. With the knob in position, install the plastic push-
pin.
4. Check for proper shifter operation (see Periodic
Maintenance/Tune-Up - Shift Cable).

Shift Cable

REMOVING
1. Remove the seat, seat back, seat base, and center
footrest.
2. Remove the cap screw and lock nut securing the shift
cable to the shift lever.
PR924A
3. From under the dash, loosen the cable adjuster nut;
then slide the cable forward out of the bracket.
24
HDX261A
4. Remove the E-clip securing the cable end to the shift
arm stud.
HDX251C
5. Loosen the adjuster nut; then remove the shift cable
from the bracket. Remove any cable ties securing the
shift cable to the chassis noting their location; then
remove the shift cable.
HDX262A
 NOTE: If the cable is being replaced, connect the
new cable to the end of the existing cable and pull the
new cable into place.
INSTALLING
1. Route the cable into position making sure there are
no kinks or sharp bends. Verify the cable is routed on
top of the frame as indicated below.